Free Sales Ending Soon - Use Real 350-601 PDF Questions [Nov 27, 2023]
Updated Nov-2023 Exam 350-601 Dumps - Pass Your Certification Exam
NEW QUESTION # 50
An engineer performs a Firmware Auto Install upgrade through the Cisco UCS Manager. Which two Cisco UCS components are upgraded in the Install Server Firmware stage? (Choose two)
- A. Cisco UCS C-Series Rack-Mount Server
- B. Cisco UCS B-Series Blade Server
- C. I/O Modules
- D. Fabric Interconnects
- E. Cisco UCS Manager
Answer: C,D
NEW QUESTION # 51
Refer to the exhibit.
Cisco Fabric Services is enabled in the network. Which type of IP address is used by the Cisco Fabric Services protocol?
- A. IPv4 gateway address
- B. IPv4 anycast address
- C. IPv4 unicast address
- D. IPv4 multicast address
Answer: D
NEW QUESTION # 52
What is the benefit of adding Cisco HyperFlex Hardware Acceleration Cards to a HyperFlex deployment?
- A. increased network throughput
- B. offline encryption acceleration
- C. GPU acceleration
- D. increased compression efficiency
Answer: D
NEW QUESTION # 53
A customer has a requirement for an automation solution that supports periodically acquiring configuration from a centralized server and aligning UCS servers to their desired state. Which open-source tool meets these requirements?
- A. Puppet
- B. Terraform
- C. SaltStack
- D. Kubemetes
Answer: A
Explanation:
Explanation
"Overview of Puppet architecture: [...] After it receives a catalog, the Puppet agent applies the catalog by checking each resource that the catalog describes. If it finds any resources that are not in their desired state, it makes any changes necessary to correct them."
https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series-rackservers/ whitepaper_c11-740103.pdf
https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-devops-integration-sol-br from DCCOR book under Puppet section The operation of the Puppet agent involves periodically connecting to the Puppet master, which in turn compiles and sends a configuration manifest to the agent. The agent reconciles this manifest with the current state of the node and updates state that is based on differences.
NEW QUESTION # 54
Refer to the exhibit.
Which two Cisco UCS components are upgraded as a result of the configuration? (Choose two.)
- A. BIOS
- B. board controller
- C. IOMs
- D. adapters
- E. Cisco UCS Manager
Answer: C,E
NEW QUESTION # 55
An engineer is configuring VNTag between a virtualized server and a Cisco Nexus 5500 Series switch. Drag and drop the configuration steps from the into the correct order on the right.
Answer:
Explanation:
Explanation
install the virtualization feature set
Enable the virtualization feature set
Configure the port profile
Configure support for VNTag mode on the interface that connects to the server.
Configure the server to support NIV mode
Configure the vNICs of the server
NEW QUESTION # 56
Drag and drop the technologies from the left onto the description on the right.
Answer:
Explanation:
NEW QUESTION # 57
An engineer is implementing the Cisco ACI fabric and must create two different vPCs from leaf switches A and B. The vPCs are deployed as follows:
* vPC 1 encompasses ports Eth 1 /1 on leaf A and B and connects to server 1.
* vPC 2 encompasses port Eth1/2 on leaf A and B and connects to server 2.
A leaf switch profile listing leaves A and B is already configured Which ACI object must be created to meet these requirements?
- A. two PortChannel interface policy groups
- B. one vPC interface policy group
- C. two vPC interface policy groups
- D. one access port interface policy group
Answer: C
NEW QUESTION # 58
Refer to the exhibit.
All switches are configured with the default OSPF priority. Which configuration should be applied to ensure that the SW2 Cisco Nexus switch controls the LSA floods and advertises the network to the remaining nodes in the OSPFv2 area?
- A. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 0
- B. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 1
- C. SW2# configure terminal SW2 (config)# interface ethernet 1/1 SW2 (config-if)# ip ospf priority 255
- D. SW2# configure terminal SW2 (config)# router ospf 1 SW2 (config-router)# router-id 10.10.10.22
Answer: C
Explanation:
Priority in OSPF is mainly used to influence/determine a designated router/backup designated router for a network. By default, the priority is 1 on all routers. A router with a high priority will always win the DR/BDR election process.
NEW QUESTION # 59
A network engineer connects the CNA interface of a server to a switch. The switch must bring down all of the VLANs on the interface that are not enabled for FCoE, but the VLANs that are enabled for FCoE should continue to carry SAN traffic without interruption. Which configuration should be applied to the switch to achieve this objective?
- A. switch(config)# interface Ethernet 2/1 switch(config-if)# shutdown Ian
- B. switch(config)# interface Ethernet 2/1 switch(config-if)# shutdown force
- C. switch(config)# Interface Ethernet vfc 2 switch(config-if)# shutdown force
- D. switch(config)# interface vfc 2 switch(config-if)# shutdown Ian
Answer: A
NEW QUESTION # 60
Refer to the exhibit.
Why does the python code for Cisco NX-API print error message?
- A. The JSON is not a supported format for the NX-API.
- B. The "type" is wrong in the header of the request and should be "cli_ conf".
- C. The "type" is wrong is the body of the request and should be "cli_ conf".
- D. NX-API does not allow configuration for features via the requests module.
Answer: C
NEW QUESTION # 61
Which two actions should be taken before an upgrade is started on a Cisco MDS switch? (Choose two.)
- A. back up the configuration
- B. check the impact of the upgrade using the show install all impact command
- C. make the primary supervisor the active supervisor
- D. disable Cisco Fabric Services
- E. free up space on the USB3 device by deleting old Cisco NX-OS image files
Answer: A,B
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/5_2/upgrade/guides/nx-os/ upgrade.html
NEW QUESTION # 62
Which two statements about the process of performing an EPLD upgrade on a Cisco MDS 9000 series Switch are true? (Choose two.)
- A. The upgrade can be performed from the standby supervisor module.
- B. Modules must be online to be upgraded.
- C. The Upgrade process disrupts only the module that is being upgraded.
- D. The active supervisor can be upgraded.
- E. If an upgrade is interrupted, the upgrade continues after a connection is restored.
Answer: B,C
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/8_x/release_notes/epld/epld_rn_8x.htm
NEW QUESTION # 63
An engineer is implementing NetFlow on a Cisco Nexus 7000 Series Switch. Drag and drop the NetFlow commands from the left into the correct order they must be entered on the right.
Answer:
Explanation:
NEW QUESTION # 64
A network engineer must prevent data comuption due to cross fabric communication in an FCoE environment.
Which configuration must be applied to the Cisco Nexus Unified Switches to achieve this objective?
- A. Switch(config)#fcoe fcmap 0e,fc,2a
- B. Switch(config) # no fcoe fcf-priority
- C. Switch(config-if)# no fcoe fcf-priority 0
- D. Switch(config-if) # shutdown lan
Answer: A
NEW QUESTION # 65
An engineer is using REST API calls to configure the cisco APIC. Which data structure must be used within a post message to receive a login token?
A)
B)
C)
D)
- A. Option D
- B. Option A
- C. Option C
- D. Option B
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/rest_cfg/2_1_x/ b_Cisco_APIC_REST_API_Configuration_Guide/b_Cisco_APIC_REST_API_Configuration_Guide_chapter_01.html
NEW QUESTION # 66
Refer to the exhibit.
A network engineer is setting up a multihomed OTV network. The first site has been set up with a primary and secondary adjacency server. Which configuration must be added on the remote OTV AEDs site?
- A. interface Overlay200
otv join-interface Ethernet1/2
otv extend-vlan 178, 2500-2563
otv use-adjacency-server 20.1.1.1 unicast-only - B. interface Overlay200
otv join-interface Ethernet1/2
otv extand-vlan 178, 2500-2563
otv adjacency-server unicast-only - C. interface Overlay200
otv join-interface Ethernet1/2
otv extend-vlan 178, 2500-2563 - D. interface Overlay200
otv join-interface Ethernet1/2
otv extend-vlan 178, 2500-2563
otv use-adjacency-server 20.1.1.1 20.2.1.1 unicast-only
Answer: D
NEW QUESTION # 67
Refer to the exhibit.
What is the reason the system-fm-vrrp checkpoint was created?
- A. The network administrator manually created it.
- B. The VRRP-enabled feature has been disabled.
- C. The VRRP process crashed and the checkpoint was automatically created.
- D. The VRRP service restarted and the checkpoint was automatically created.
Answer: B
Explanation:
Section: Network
NEW QUESTION # 68
Which two components should be checked when a Cisco Nexus 9000 Series Switch fails to boot using POAP?
(Choose two.)
- A. DHCP server to bootstrap IP information
- B. TFTP server that contains the configuration script
- C. script signed with security key
- D. image noted in the script file against switch bootflash
- E. POAP feature license
Answer: A,B
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/7-x/troubleshooting/guide/ b_Cisco_Nexus_9000_Series_NX-OS_Troubleshooting_Guide_7x/b_Cisco_Nexus_9000_Series_NXOS_ Troubleshooting_Guide_7x_chapter_01100.html
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/7-x/fundamentals/configuration/ guide/b_Cisco_Nexus_9000_Series_NX-OS_Fundamentals_Configuration_Guide_7x/ b_Cisco_Nexus_9000_Series_NX-OS_Fundamentals_Configuration_Guide_7x_chapter_0100.html
NEW QUESTION # 69
Refer to the exhibit.
Which backup operation type does not include the Preserve Identities feature?
- A. logical configuration
- B. system configuration
- C. full state
- D. all configuration
Answer: C
Explanation:
This checkbox remains selected for All Configuration and System Configuration. Full State backup does not have Preserver Identity feature.
All configs, logical and system backups seem to allow "preserve identities":
https://books.google.pt/books?id=5VXUDwAAQBAJ&pg=PT699&lpg=PT699&dq=Preserve+Identities
+feature+backup+ucs&source=bl&ots=daWxti4DV&
sig=ACfU3U3X8UlPtS8EewzRIqTxqpyNVqOaNQ&hl=es419&
sa=X&ved=2ahUKEwiYhtaxyMDqAhXFzIUKHXl8CzoQ6AEwC3oECAoQAQ#v=onepage&q=Preserve
%20Identities%20feature%20backup%20ucs&f=false
NEW QUESTION # 70
An engineer must configure a Nexus 7000 series switch for HSRP on VLAN 100. When fully functional, the router must be the active master. Which set of commands must be used to implement the scenario?
- A. Option C
- B. Option D
- C. Option A
- D. Option B
Answer: C
NEW QUESTION # 71
An engineer is enabling port security on a Cisco MDS 9000 Series Switch.
Which feature of enabling port security on a Cisco MDS 9000 Series Switch must be considered?
- A. It can be distributed by using Cisco Fabric Services.
- B. It authorizes only the configured sWWN to participate in the fabric.
- C. It always learns about switches that are logging in.
- D. It binds the fabric at the switch level.
Answer: A
NEW QUESTION # 72
An engineer must configure a Cisco UCS domain for monitoring and management by the Cisco Intersight SaaS platform. After the setup is complete, administrators must have full control to configure the device through Cisco UCS Manager and Intersight. Which set of actions accomplishes this task?
- A. Option D
- B. Option A
- C. Option C
- D. Option B
Answer: C
NEW QUESTION # 73
Refer to the exhibit.
What is the outcome of this command when the ELPD is updated on a Cisco Nexus 9000 series switch?
- A. shows a simulated upgrade of the EPLD
- B. displays the compatibility of the EPLD upgrade and the image in the bootflash
- C. displays the impact of the upgrade on the operation of the switch
- D. upgrades the EPLD on the switch disruptively
Answer: C
NEW QUESTION # 74
Refer to the exhibit.
What is the result of this series of commands?
- A. It verifies the firmware update on the server.
- B. It updates the firmware on adapter 1/1/1 immediately.
- C. It activates the firmware on the next adapter boot.
- D. It reboots the server immediately.
Answer: C
NEW QUESTION # 75
......
350-601 Dumps To Pass CCNP Data Center Exam in One Day: https://passleader.realexamfree.com/350-601-real-exam-dumps.html
